1/2/2023 0 Comments How to use ham radio deluxe![]() If you need more assistance, please let us know what the whole station setup is. So without a bit more info I can't give you a specific answer. You'd have to check your manual if using one. Some rig interfaces may also provide CW keying. This can be as simple as a reed relay across the bit line and ground on the parallel port (relay coil across the bit and ground, NO contact to the key input), or more elaborate setup. ![]() After the software is configured, you need to extend the control to some form of circuity that will key the rig. Either via the serial port (and selecting DTR as the CW control line) or the parallel port (and selecting the appropriate bit). There are two methods available to do this. The CW mode needs to control the key line on your rig. If you don't have the sound card interfaced into your rig, there's another method available to you. However, some users have had issues when they add an RSP to the mix and SDRuno software. This method creates the tone on the sound card and transmits via the Mic connector (or other audio connector). Using Ham Radio Deluxe with SDRuno Ham Radio Deluxe (HRD) is very popular with many hams who use it for logging, digital decoding and/or rig control. If that's correct, then you need to be in the MCW (Modulated CW) mode and USB on your rig. From the other computer add a log and point to the shared. Once that is done, share the folder using standard file sharing methods and mad a drive to this share on the other computer. That is, you can successfully complete a PSK31 QSO. Easiest way to do this is locate the Logbook on you primary computer as it of course will need to be on to perform updates/entries. ![]() Since it was not specifically said in your question, I assume you have the sound card plugged into the rig. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |